Step by step directions for gluing inner corners
When finishing, the major problem can be uneven walls and the resulting springs on the background. It is also crucial to take into consideration that if the walls are twisted the joints of wallpaper canvases may diverge.
After gluing the previous one in front of the interior corner of the fabric should measure the remaining space. It is measured from the border of the pasted cloth to the adjoining wall, the resulting amount is added 10-15 millimeters. If the partitions are extremely curved, then the further figure may be .
Cut a strip equal to the resulting figure, taking into account the allowance. The surfaces are treated with glue. Depending on the kind of coat it may be exactly the wall or both surfaces.
The strip is glued independently with the cut side into the wall. The background should go on the other plane.
If the glued wallpaper is wrinkled, you want to make a few modest cuts perpendicular to the folds.
Level or slope on the adjacent wall is a vertical lineup. The distance in the corner is equivalent to the width of the preceding cut strip, not adding developments.
The surfaces have been smeared with adhesive, and then the coat is glued into the wall using the flat side towards the marked line. The cut goes on the adjacent wall.
The best way to glue the outer corner (outer corner)?
Protruding corner ought to be glued by analogy with the interior, however there are small gaps, which also need to be taken into gidpola.ru account when working.
Measured the space remaining in the glued background to the adjoining wall. Add 20-25 millimeters to the obtained figure.
A section is cut away, considering the additional 20-25 millimeters.
Prior to gluing, the surfaces are treated with glue.
The edge must be glued into the background already fixed onto the wall, your own cut side”goes” to the next plane. If needed, small cuts are created in the place of going to the other wallpaper, smoothed and pressed to the wall.
Draw a vertical strip onto the adjoining wall at a distance of only glued cut strip and 6-10 millimeters.
After applying the adhesive, the strip is put on the wall with its flat side towards the marked line, going over the border of the already glued strip.
The joints are smeared with glue and ironed with a roller. After that, the upper layer is cut along the ruler and the 2 layers are joined together.
